Thanks Elms (Again)

[Bounce]

Thanks to Elms,picked up the CSL today with its shiny new boot floor,new trailing arm bushes with my limiter kit,new input shaft seal on the diff and new ATE super blue brake fluid.

[rstoughy]

Nice one Brett

I wish my boot floor would fall to bits, 15mths left to do it

[Bounce]

Originally Posted by rstoughy

Nice one Brett

I wish my boot floor would fall to bits, 15mths left to do it

You could only just see mine,have a good look under there Paul,my crackwas only about 20mm long and sometimes you can't even see them as they are under and around the 4 subframe bushes.

[mattCSLnut]

Originally Posted by Bounce

You could only just see mine,have a good look under there Paul,my crackwas only about 20mm long and sometimes you can't even see them as they are under and around the 4 subframe bushes.

Yep, as Bres said they are very small and hidden well sometimes.
Mine was the same, just creeping out from under one of the rear sub frame bushes but Eagle Eyed Gareth found it during an Inspection 1 last year.

[Yanto]

Originally Posted by Bounce

You could only just see mine,have a good look under there Paul,my crackwas only about 20mm long and sometimes you can't even see them as they are under and around the 4 subframe bushes.

Not according to last Mantrain pic I saw !

[Straightsix]

Originally Posted by Bounce

Thanks to Elms,picked up the CSL today with its shiny new boot floor,new trailing arm bushes with my limiter kit,new input shaft seal on the diff and new ATE super blue brake fluid.

What is the fix ? Is it just replace the parts of standard spec which would mean can easily happen again or were parts replaced to a much higher better specification regarding the rear subframe and boot floor :-) ?

Thanks very much

[billyboysm3]

I dont know shit, but have heard it is a strengthened floor by someone on here as part numbers are different.

[Bounce]

Originally Posted by billyboysm3

I dont know shit, but have heard it is a strengthened floor by someone on here as part numbers are different.

The cavity is also injected with structural foam.

[shimmy]

Originally Posted by billyboysm3

I dont know shit, but have heard it is a strengthened floor by someone on here as part numbers are different.

i think the new floor pan has a ridge in it to strenghten it, and then the foam bonding agent

[Straightsix]

So could this easily happen again in 10 years or will this have sorted this out for the next 30 years :-) ?