Fitting flippers to bumper

M3 KVU · 29-05-2018, 01:04 PM

Was just trying to fit mine to my new bumper and is there a knack to it so they sit bang on ??

**Mike R** · 29-05-2018, 03:20 PM

Sledge hammer and cold chisel, if that doesn't work - blow torch

.

What seems to be the problem with the alignment, I didn't think you could fit them wrongly?

M3 KVU · 29-05-2018, 05:40 PM

Lol that would work !

Seems tight to slip on at the inside ends then tuck the flap at the top under the bumper , almost seems like they need trimming at the top part.

**Mike R** · 30-05-2018, 10:06 AM

They do need a bit of persuasion, but shouldn't need trimming

GregorFuk · 30-05-2018, 11:27 AM

They go in using a diagonal movement as I remember. Start at the inside end and move them upwards and inwards.

M3 KVU · 30-05-2018, 03:07 PM

Thank you gents.

M3 KVU · 04-06-2018, 01:53 PM

All sorted , just had to trim a little bit at the top.

29-05-2018, 01:04 PM	#1
M3 KVU S2 - Picking it up Join Date: May 2015 Posts: 61 Casino cash: $4171	Fitting flippers to bumper Was just trying to fit mine to my new bumper and is there a knack to it so they sit bang on ??

29-05-2018, 03:20 PM	#2
Mike R S6, Sport On, Traction Off Join Date: Dec 2010 Location: Norwich Posts: 1,586 Casino cash: $17592	Sledge hammer and cold chisel, if that doesn't work - blow torch . What seems to be the problem with the alignment, I didn't think you could fit them wrongly? __________________ Mike R Sarcasm is just a free service I provide. Nordschleife, there's only two barriers to worry about - the ones on the left and the ones on the right . CSL number 044

30-05-2018, 10:06 AM	#4
Mike R S6, Sport On, Traction Off Join Date: Dec 2010 Location: Norwich Posts: 1,586 Casino cash: $17592	They do need a bit of persuasion, but shouldn't need trimming __________________ Mike R Sarcasm is just a free service I provide. Nordschleife, there's only two barriers to worry about - the ones on the left and the ones on the right . CSL number 044

29-05-2018, 05:40 PM	#3
M3 KVU S2 - Picking it up Join Date: May 2015 Posts: 61 Casino cash: $4171	Lol that would work ! Seems tight to slip on at the inside ends then tuck the flap at the top under the bumper , almost seems like they need trimming at the top part.

30-05-2018, 11:27 AM	#5
GregorFuk S5 - Full Throttle Join Date: Nov 2014 Posts: 318 Casino cash: $11097	They go in using a diagonal movement as I remember. Start at the inside end and move them upwards and inwards.

30-05-2018, 03:07 PM	#6
M3 KVU S2 - Picking it up Join Date: May 2015 Posts: 61 Casino cash: $4171	Thank you gents.

04-06-2018, 01:53 PM	#7
M3 KVU S2 - Picking it up Join Date: May 2015 Posts: 61 Casino cash: $4171	All sorted , just had to trim a little bit at the top.