Mounting intrax rear

[M3 UFE]

Got some intrax waiting to go on
I understand the best way of mounting the rear coilovers upside down
So I removed the top mount bracket to bolt on the other side and the gap is not wide enough to fit, do I need to bend the bracket to make for or is there another way

[adem.csl]

Originally Posted by M3 UFE

Got some intrax waiting to go on
I understand the best way of mounting the rear coilovers upside down
So I removed the top mount bracket to bolt on the other side and the gap is not wide enough to fit, do I need to bend the bracket to make for or is there another way

You should have a u shape bracket with a stud on it that you bolt into the top mount then the bolt goes through the u shape holding the shock in the middle
Yes mounting the shock upside down
Post a pic of the shock and bracket

[M3 UFE]

Originally Posted by adem.csl

You should have a u shape bracket with a stud on it that you bolt into the top mount then the bolt goes through the u shape holding the shock in the middle
Yes mounting the shock upside down
Post a pic of the shock and bracket

ya thats what I have but the U bracket is not wider enough to fit the other side as it a little bit wider

[billyboysm3]

Welcome to the forum, they should look like this:

Rears, left and right:

[M3 UFE]

Originally Posted by billyboysm3

Welcome to the forum, they should look like this:

Rears, left and right:

ya they look like that at the moment, but want to mount them inverted so I can adjust them from the bottom

[billyboysm3]

Or jack car up and amend at track, takes 2 min, dont be a plonker like me and set it to soft .

[M3 UFE]

Think I might do that,
adjusting the stiffness is it clock wise to stiffen

[billyboysm3]

Yes thats correct.

[s.mac]

and dont forget the z4 (it could be z3..)strengthening plates to fit inside the car !

[M3 UFE]

Originally Posted by s.mac

and dont forget the z4 (it could be z3..)strengthening plates to fit inside the car !

ya got them but have a rear bar on the turrets