10-05-2011, 09:28 PM | #31 | |
CSL Register Uber-poster!
Join Date: Apr 2008
Location: Uk
Posts: 14,646
Casino cash: $43909 |
Quote:
Alex, why does cylinder to cylinder leak cause higher temps at full throttle then?
__________________
. |
|
10-05-2011, 10:27 PM | #32 | |
CSL Register Uber-poster!
Join Date: Feb 2009
Location: warrington
Posts: 5,419
Casino cash: $19783 |
Quote:
These are all just theories, Each part only has to be minute to create overheating issues Once it's got too hot once then I feel damage is already done, ticking timebomb then. Try the basics first, forget your fan, it's got fuck all to do with it, unless it overheated whilst stationary at an earlier date. We had a similar problem on a big powered Evo It left us and several big tuners scratching our heads. We looked at it from a very basic angle, tried a thermostat as it was basic diagnosis and it fixed it. Said tuner had done all kinds of things to remedy it, as they built the engine from scratch, the problems started soon after. They even wire rung the head A preventative measure that masked rather than cured. Same fault happened again. We replaced stat and problem fixed. |
|
10-05-2011, 11:38 PM | #33 |
S5, Sport Off, DSC M-track
Join Date: Apr 2010
Location: Sussex
Posts: 613
Casino cash: $5830 |
Lawsy & Shimmy - agree with your theories, not sure about Alex's case, but my fluctuation in water temp does not follow high oil temp. My water temp is moving about without the oil going over 100, (only 1-2mm left and right of the centre of the gauge in normal driving) so I've been advised to change the thermostat first.
As soon as I have done so i'll report back - good thing is I'll know as soon as I've done it whether it's fixed the problem as it shouldn't move at all. (or so I've been told) Fingers crossed |
10-05-2011, 11:55 PM | #34 | |
CSL Register Uber-poster!
Join Date: Feb 2009
Location: warrington
Posts: 5,419
Casino cash: $19783 |
Quote:
Hope it's a simple fix for you. |
|
11-05-2011, 11:58 AM | #35 | |
CSL Register Uber-poster!
Join Date: Apr 2008
Location: Herefordshire
Posts: 4,374
Casino cash: $8572 |
Quote:
Shim, any transfer of compression to another cylinder before it's ready for that particular cycle will cause heat issues. Then add combustion to that other cylinder as well (ignition from the cylinder that's lost the compression across the gasket) and you are effectively getting pre-ignition. If that is happening durring the up stroke of the next door piston.......................well, you can imagine the rest with the engine turning at 133 revs/second @ WOT.
__________________
CSL Register Alcoholics Anonymous Group Leader & Businessman of the Year '93! www.earleyengineering.com |
|
11-05-2011, 02:34 PM | #36 | |
CSL Register Uber-poster!
|
Quote:
Clearly you haven't been spending enough time on this forum lately!
__________________
Cha'mone Mother F**ker! |
|
11-05-2011, 04:20 PM | #37 |
CSL Register Uber-poster!
Join Date: Apr 2008
Location: Herefordshire
Posts: 4,374
Casino cash: $8572 |
Sorry Sir. Must try harder. Feckin' hell, sounds like every school report I ever got. Things never change.
__________________
CSL Register Alcoholics Anonymous Group Leader & Businessman of the Year '93! www.earleyengineering.com |
04-03-2012, 11:18 PM | #38 |
Driving it like I nicked it
Join Date: Mar 2009
Posts: 2,785
Casino cash: $29970 |
thermostat analysis
Today I found the time to remove my thermostat and do a comparison to the new one.
I am reminding that I had an overheating problem at the track. I was also experiencing a drop in water temp after a fast run (i.e. highway with 200km/h and then backing off, the water temp would drop... and then after a while will go back to the middle). I changed the viscus fan sometime ago as mine was dead. This solved the overheating problem but clearly the thermostat was faulty too. I ran a few tests using the traditional method of a an old pot and hot water. 1st test, put boiling water inside. The new thermostat is on the right on all pics. It opened faster but also opened wider. You can see there is a difference of 2mm. Then I quickly pulled them out for a pic. Again the difference is massive. I let them cool down and then did a 2nd test. The result was similar. 3rd test I started putting cold water inside. The old thermostat didn't close fast enough (that explains my water temp dropping when backing off). I am confident my temp issues will be totally resolved with the new thermostat. My recommendation is if someone has overheating issues to change the viscus fan and thermostat. Last but not least, a picture of my helper 'Pipis'. Last edited by alexk; 05-03-2012 at 09:44 AM. |
04-03-2012, 11:22 PM | #39 |
CSL Register Uber-poster!
Join Date: Apr 2008
Location: Uk
Posts: 14,646
Casino cash: $43909 |
Very interesting Alex, great test and nice pussy
I have my M stat fitted now so my temps are rising slower than before but no test yet of overheating issue, need 23oC + for that
__________________
. |
04-03-2012, 11:47 PM | #40 |
CSL Register Uber-poster!
Join Date: Nov 2009
Location: Cornwall
Posts: 7,057
Casino cash: $35793 |
I bet you can boil an egg to perfection Alex.
|
|
|