Can someone do me a quick favour

bryce · 10-12-2008, 06:00 PM

Now I know its bloody cold - but could someone nip out and measure the centre of their wheel to arch. Need both front and rear on a standard setup car.

Trying to get my coils set perfect for geometry tomorrow.

s.mac · 10-12-2008, 06:12 PM

34.5mm front and rear, just on a normal tape measure
thats centre and going straight up to arch

bryce · 10-12-2008, 07:36 PM

Spot on mate, thank you very much.

Currently my nose is 10mm higher, so i need to bring her down a notch or two to even it up.

Was confused because the front arch is a bit bigger - so pressumed hub-to-arch would be bigger also.

BMsport.com · 11-12-2008, 10:14 AM

Hello,

The proper way to measure the ride height is from the base of the wheel rim through the centre line to the arch.

HTH

Jags

10-12-2008, 06:00 PM	#1
bryce S5, Sport On, DSC M-track Join Date: Nov 2008 Location: Scotland (sw) Posts: 1,369 Casino cash: $2512	Can someone do me a quick favour Now I know its bloody cold - but could someone nip out and measure the centre of their wheel to arch. Need both front and rear on a standard setup car. Trying to get my coils set perfect for geometry tomorrow.

11-12-2008, 10:14 AM	#4
BMsport.com Wonky 'L' after Washing Join Date: Dec 2008 Posts: 16 Casino cash: $992	Hello, The proper way to measure the ride height is from the base of the wheel rim through the centre line to the arch. HTH Jags __________________ www.bmsport.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need a Favour !	DazBlackCSL	Jokes & Idjuts Area	2	09-02-2009 09:45 PM
need favour	dave1	Technical Area	8	19-09-2008 08:33 PM

10-12-2008, 06:12 PM	#2
s.mac CSL Register Uber-poster! Join Date: Jun 2008 Posts: 4,247 Casino cash: $15600	34.5mm front and rear, just on a normal tape measure thats centre and going straight up to arch

10-12-2008, 07:36 PM	#3
bryce S5, Sport On, DSC M-track Join Date: Nov 2008 Location: Scotland (sw) Posts: 1,369 Casino cash: $2512	Spot on mate, thank you very much. Currently my nose is 10mm higher, so i need to bring her down a notch or two to even it up. Was confused because the front arch is a bit bigger - so pressumed hub-to-arch would be bigger also.