|
|
|||||||
| Register | FAQ | Donate | Members List | Calendar | Arcade | Casino | vBGarage | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Display Modes |
21-09-2010, 10:36 AM
|
#21 |
|
CSL Register Uber-poster!
  
|
Standard bolt length on mine too - no problems.
__________________
 Cha'mone Mother F**ker! |
|
|
|
21-09-2010, 10:57 AM
|
#22 |
|
S4 - Getting the hang of it
Join Date: Sep 2009
Posts: 247
Casino cash: $11332  |
With how many turns?
|
|
|
|
|
21-09-2010, 12:14 PM
|
#23 |
|
CSL Register Uber-poster!
Join Date: Sep 2009
Location: Olney, Bucks
Posts: 3,735
Casino cash: $9984 |
As a general guide,you should be looking to get 1.5 x thread diameter of engagement in a tapped hole, but as this is a through hole, at least engage the full thickness of the bell HOWEVER beware as if you fit bolts that are too long, they will foul your backplate, and if one of your lads tasked with changing the wheels fails to notice the spacer is stuck to the inside of the wheel, and then fits tother wheel without said spacer and with long bolts, and you drive off...it fooks the backplate !
__________________
" I use Gleaming Kleen.... for that new car look " I wish I had used - Race Data Systems - Motorsport Data Loggers forgive me Nathan ! 
|
|
|
|
|
21-09-2010, 01:42 PM
|
#24 |
|
CSL Register Uber-poster!
Join Date: Jun 2008
Posts: 4,247
Casino cash: $15600  |
I just got half a dozen full turns before I started with the wrench
|
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Tetris Champion!
Linear Mode
