Airbag Light - Page 2

m3dragon · 16-10-2013, 08:57 PM

Quote:

Originally Posted by lawsy

It's under the carpet on transmission tunnel

Please remove key and disconnect battery before out mess wit bit though

yeah anytime I touch the airbags the battery is disconnected. Seen enough videos of what could happen if you do not.

Do you guys think the issue could be a faulty unit? We coded it out but that of course is not a guarantee that it will stay.

shane@mbtech · 16-10-2013, 09:33 PM

I have an airbag module from my Csl that I can sell.
It's sat on my desk at work.

shane@mbtech · 16-10-2013, 09:34 PM

Just get a resistor and stick it in the plug.

Done it many of times.

3ohms off the top of my head.

m3dragon · 16-10-2013, 09:45 PM

Tried the resister but then again it could have been wrong omhs or not installed correctly in the plug.

The info I used was as described below. Should I use a different resister or?

Thank you all in advance for the assistance.

inserted a 2.0 ohm 1/4 watt resistor w/5% resistance

shane@mbtech · 16-10-2013, 10:08 PM

I'll check my toolbox in the morning. See what the resistor is.

16-10-2013, 09:45 PM	#14
m3dragon S3 - On the open road Join Date: May 2012 Location: California Posts: 96 Casino cash: $748	Tried the resister but then again it could have been wrong omhs or not installed correctly in the plug. The info I used was as described below. Should I use a different resister or? Thank you all in advance for the assistance. inserted a 2.0 ohm 1/4 watt resistor w/5% resistance __________________ NorCal drive organizer guy Drive database and photo locations

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

16-10-2013, 09:33 PM	#12
shane@mbtech CSL Register Uber-poster! Join Date: Feb 2009 Location: warrington Posts: 5,419 Casino cash: $19783	I have an airbag module from my Csl that I can sell. It's sat on my desk at work.

16-10-2013, 09:34 PM	#13
shane@mbtech CSL Register Uber-poster! Join Date: Feb 2009 Location: warrington Posts: 5,419 Casino cash: $19783	Just get a resistor and stick it in the plug. Done it many of times. 3ohms off the top of my head.

16-10-2013, 10:08 PM	#15
shane@mbtech CSL Register Uber-poster! Join Date: Feb 2009 Location: warrington Posts: 5,419 Casino cash: $19783	I'll check my toolbox in the morning. See what the resistor is.