Window Switch Trim Removal

[Mark CSL]

This is how to change the window switch trim I am fitting a carbon one
Tools needed are a Phillips Screw Driver


Pull up on the gear knob It will come off in your hand


Then pull up on this part when off release the green connector


Then remove the 2 screws You can see the Green connector on the right


Unclip the window switches on each side there are 2 clips on each side


Fit the switches in the new panel then place it down from the astray to the front then fit the 2 screws


Fit the rest of the trims not forgetting to connect the green connector
This is the finished part


I sell the carbon ones PM me for details