Cannot set rear camber

**portlandgrey** · 20-03-2013, 07:44 PM

I've just had the rear floorpan replaced by BMW & while the axle was off I had new OEM RTAB's & a turner limiter kit fitted, along with all new axle carrier bushes.

In the KDS print, the rear camber is out - it should be 1,5 & is actually measuring 1.18 & 1.33. Dealer says its due to the limiter kit & there is now not enough adjustment available.
Does this sound correct?

Also the front 20degree castor is out - the target spec is 7.48, mine is actually 6.58 & 7.03.

The car feels floaty at the front & not at all connected to the back.

Any advice welcome.

20-03-2013, 07:44 PM	#1
portlandgrey S4 - Getting the hang of it Join Date: Jan 2010 Posts: 153 Casino cash: $8449	Cannot set rear camber I've just had the rear floorpan replaced by BMW & while the axle was off I had new OEM RTAB's & a turner limiter kit fitted, along with all new axle carrier bushes. In the KDS print, the rear camber is out - it should be 1,5 & is actually measuring 1.18 & 1.33. Dealer says its due to the limiter kit & there is now not enough adjustment available. Does this sound correct? Also the front 20degree castor is out - the target spec is 7.48, mine is actually 6.58 & 7.03. The car feels floaty at the front & not at all connected to the back. Any advice welcome.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode