no csl...but my baby....

[nick///M3]

Originally Posted by englebert

Very nice! Dread to think what you've spent on that...

tell me about it.....

[Jeroen Olthof]

Damn, that's one fine looking M3. Well done!

[NZ_M3]

Originally Posted by nick///M3

yes i got it !!!

no problem with all the tubing from the csl for the front and bigger hole in the bumper. the one that ends up in the flap of the intake...

the problem was with the second tube of the intake that ends up in the bumper but beside the big hole...
the bumper did not have anything to put it on...so i put the end of the tube in the middle mesh....

i am talking about numbers 9-10 (1st pic ) and 21(2nd pic)

i am now removing these plastic tubes and changing them with some samco silicone hoses cause they are to close to the pulleys and i had some issues there...will post some pics here after the install...

get the bumper and use it to track your car ( if thats what you are thinking ) and save the OEM EXPENSIVE one for later....

Cheers for the reply Nick ... so what you are saying is part number 7 lines up with the Euro-spec bumper intake hole? I've always thought the Euro-spec intake hole was further towards the left hand side (facing the car) compared to the OEM CSL front bumper?? Sorry for all the questions.

[nick///M3]

Originally Posted by NZ_M3

Cheers for the reply Nick ... so what you are saying is part number 7 lines up with the Euro-spec bumper intake hole? I've always thought the Euro-spec intake hole was further towards the left hand side (facing the car) compared to the OEM CSL front bumper?? Sorry for all the questions.

actually number 7 barely touches the front if you get better fitment you should not have any problems
i used a samco tube there to make the connection....