Carbon Air flow cover

[CraigMillwardCroft]

Originally Posted by Neil M

Looking good but what happened to the proposed CSL Graphic, forgot or thought better of it?

He got is little finger stuck making the hole in his latest project

[Mark CSL]

Originally Posted by Neil M

Looking good but what happened to the proposed CSL Graphic, forgot or thought better of it?

The one i had just did not look cool .

Doing some more dash trims and fuse box lid i will post up some pictures when done

I put a set of dash trims on ebay and they sold within an hour of listing them
so 2 more sets in production

[Mark CSL]

Originally Posted by alexk

It looks good Mark !

BTW, what is wrong with your ram-air hole grille.
It should be sitting at 45 degrees.

Sorry Alex did not spot that i will get it sorted m8

Originally Posted by CraigMillwardCroft

Nice work Mark, that is a real clean engine bay, how do you get into all those tiny places

Hover and small brush

[SachaR]

Looking good Mark , just out of interest, did you use polyester or epoxy resin?

[shimmy]

Truely remarkable Mark, such dexterity from a northern man with fat fingers

[Mark CSL]

Originally Posted by SachaR

Looking good Mark , just out of interest, did you use polyester or epoxy resin?

I used the epoxy resin i have other resin that sets in 1 hour but has a green tint to the carbon when you build up the coats.

The epoxy i use takes around 3 hours to get tacky and 24 hours to get hard enough to sand.

Originally Posted by shimmy

Truely remarkable Mark, such dexterity from a northern man with fat fingers

Thanks Shimmy I Think ?

[SachaR]

Epoxy is also much harder and resistant than polyester. I was just asking as I have used both for other applications and lately a lot of epoxy to make actual parts.

Will have to give it a try on some parts....

[Mark CSL]

I am just playing around with it its fun

[NZ_M3]

Your intake grill on the bumper is crooked Mark ...

Otherwise