Carbon Splitters Refurb

[karbonkid]

Originally Posted by NZ_M3

Superb work on the bumper Alex ... time to open your own repair shop me thinks

Back off! Me not doing another fooker!!

Ta thou, I was well impressed with the results from just a series of aerosols. So much so I rewound time so I could take pics of prep stages so you lot can ave a go.

[M5 Powered]

Finally got round to picking up my splitters which were refurbed by Perkins.

The result? For 85 quid they look new. I can't even see where the stone chips were! Pics to follow.

[s.mac]

Alex, bumper looks mint ! i like to do a bit of diy but that is going some

[sailorbaz]

Alex, you said you used Rattle cans, where did you get them? Online or local? A local Motor factor can get our SG made up in Aerosols but I'm concerned as to the match. I also found some on Ebay, WA08 is it? Comes in two cans, £20 for the paint and the lacquer.

Thanks in advance, Baz

[glendog74]

A08 - Silber grau

[Dan]

Originally Posted by karbonkid

Afraid not no, never dealt with them before.

For peps in Reading area theres a good chap, Noel @ NUR-Motorsport . He manufactures carbon parts/ Repairs.

Alex, any first hand experience of this guy mate?

[Dan]

Originally Posted by glendog74

A08 - Silber grau

You're up early!

[sailorbaz]

Originally Posted by glendog74

A08 - Silber grau

Thanks Robert. It is Sunday after all,

[karbonkid]

Originally Posted by sailorbaz

Alex, you said you used Rattle cans, where did you get them? Online or local? A local Motor factor can get our SG made up in Aerosols but I'm concerned as to the match. I also found some on Ebay, WA08 is it? Comes in two cans, £20 for the paint and the lacquer.

Thanks in advance, Baz

Got the cans at my local Autoshop off the shelf luckily.
As far as colour match goes, any A08 should match up regardless of makes, simply due to standard mix ratios being identical. Colour match will appear slightly different until lacquer is applied thou.

Originally Posted by Dan

Alex, any first hand experience of this guy mate?

I haven't Dan but I have seen and heard his work is brill!

http://www.streetfire.net/video/nur-...rsr_637028.htm

[billyboysm3]

Originally Posted by M5 Powered

Finally got round to picking up my splitters which were refurbed by Perkins.

The result? For 85 quid they look new. I can't even see where the stone chips were! Pics to follow.

M5 Powered, after putting some miles on the splitters since the refurb how are the holding up?

Shimmy same to you?

Probably get mine done in the next couple of months.