Airbox intake pipe

Justin · 23-01-2011, 09:06 PM

Had to remove and re-fit the front bumper today. Everything seemed to go ok but couldn't get the two ends (triangular in shape) of the airbox intake pipe to connect back up. I wasn't paying much attention when I removed this bit as I was on my own and the bumper was just about to fall. I'm assuming the bumper end of the pipe goes over the airbox end but I just couldn't get it to fit. Gave up / ran out of time in the end and just left them resting against each other. Any tips or something I'm not doing right?

23-01-2011, 09:06 PM	#1
Justin S2 - Picking it up Join Date: May 2009 Location: Northern Ireland Posts: 41 Casino cash: $1195	Airbox intake pipe Had to remove and re-fit the front bumper today. Everything seemed to go ok but couldn't get the two ends (triangular in shape) of the airbox intake pipe to connect back up. I wasn't paying much attention when I removed this bit as I was on my own and the bumper was just about to fall. I'm assuming the bumper end of the pipe goes over the airbox end but I just couldn't get it to fit. Gave up / ran out of time in the end and just left them resting against each other. Any tips or something I'm not doing right?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode