CSL Steering Rack

Craig · 27-01-2010, 08:15 PM

I have a CSL steering rack available, it'll require two new tie rod ends / rack arms and one rubber boot to make it whole again. But the mechanical function of the rack is just fine.

I'll post some pictures later, but like I said this rack is not complete, I can supply some arms (they were pulled out of the socket) however I'd replace them for good measure.

PM, e-mail; craig@cmpracing.co.uk or phone/text 07737 3844557.

shane@mbtech · 27-01-2010, 08:30 PM

Quote:

Originally Posted by Craig

I have a CSL steering rack available, it'll require two new tie rod ends / rack arms and one rubber boot to make it whole again. But the mechanical function of the rack is just fine.

I'll post some pictures later, but like I said this rack is not complete, I can supply some arms (they were pulled out of the socket) however I'd replace them for good measure.

PM, e-mail; craig@cmpracing.co.uk or phone/text 07737 3844557.

Out of interest craig how do you know its mechanically fine if you have not fitted the tie rods and connnected it up to a pressurised pas system to rule out leaks?

Wouldnt want someone to fit it and end up with a csl like yours when the steering locks up.

Craig · 27-01-2010, 09:00 PM

Had a local hydraulic place take a look, they claimed to pressure it up to check for leaks and everything was fine. Obviously I have not bolted it up to a car and run it, although if it fits my e36 I might just do that, and keep it on there!!

Depending on the interest, I'm tempted to send it to powersteering.co.uk and get them to re-build it and then sell it at a higher premium complete. This all depends on interest, I am making any potential buyer aware of everything. As most know, I refused to even sell this rack until someone else had looked at it!

mattCSLnut · 27-01-2010, 09:12 PM

Quote:

Originally Posted by Craig

Had a local hydraulic place take a look, they claimed to pressure it up to check for leaks and everything was fine. Obviously I have not bolted it up to a car and run it, although if it fits my e36 I might just do that, and keep it on there!!

Depending on the interest, I'm tempted to send it to powersteering.co.uk and get them to re-build it and then sell it at a higher premium complete. This all depends on interest, I am making any potential buyer aware of everything. As most know, I refused to even sell this rack until someone else had looked at it!

That's a very honorable attitude Craig

Top marks. BTW the Business CD player out of your CSL lives on happily in my CSL

THANX again.

shane@mbtech · 27-01-2010, 09:27 PM

Quote:

Originally Posted by Craig

Had a local hydraulic place take a look, they claimed to pressure it up to check for leaks and everything was fine. Obviously I have not bolted it up to a car and run it, although if it fits my e36 I might just do that, and keep it on there!!

Depending on the interest, I'm tempted to send it to powersteering.co.uk and get them to re-build it and then sell it at a higher premium complete. This all depends on interest, I am making any potential buyer aware of everything. As most know, I refused to even sell this rack until someone else had looked at it!

I wasnt being funny with my post craig, I was just trying to clarify,

If you fully refurbed it with boots, tie rods and track rod ends I think you would get better return,

weedavey · 27-01-2010, 09:41 PM

Quote:

Originally Posted by mattCSLnut

That's a very honorable attitude Craig

I agree, well done bud.

Craig · 28-01-2010, 03:09 PM

Lawsy, I know you wernt... out of interest anyone know what a fully refurbushed rack is worth?

**shimmy** · 28-01-2010, 03:13 PM

Quote:

Originally Posted by mattCSLnut

........ BTW the Business CD player out of your CSL lives on happily in my CSL

THANX again.

yes but it is totally pissed off with constantly playing Kylie and show tunes

mattCSLnut · 28-01-2010, 04:51 PM

Quote:

Originally Posted by Craig

Lawsy, I know you wernt... out of interest anyone know what a fully refurbushed rack is worth?

A little bit less then a Brand New one ???

**shimmy** · 28-01-2010, 05:17 PM

Quote:

Originally Posted by mattCSLnut

A little bit less then a Brand New one ???

on something like a steering rack i think i would only offer 'a lot less' as its had probably half its life anyway and been in a major bang

good luck Craig, would like it as a spare but only if it is sound (and cheap)

27-01-2010, 08:15 PM	#1
Craig S5 - Full Throttle Join Date: Jun 2009 Location: Guisborough Posts: 453 Casino cash: $4472	CSL Steering Rack I have a CSL steering rack available, it'll require two new tie rod ends / rack arms and one rubber boot to make it whole again. But the mechanical function of the rack is just fine. I'll post some pictures later, but like I said this rack is not complete, I can supply some arms (they were pulled out of the socket) however I'd replace them for good measure. PM, e-mail; craig@cmpracing.co.uk or phone/text 07737 3844557.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

27-01-2010, 09:00 PM	#3
Craig S5 - Full Throttle Join Date: Jun 2009 Location: Guisborough Posts: 453 Casino cash: $4472	Had a local hydraulic place take a look, they claimed to pressure it up to check for leaks and everything was fine. Obviously I have not bolted it up to a car and run it, although if it fits my e36 I might just do that, and keep it on there!! Depending on the interest, I'm tempted to send it to powersteering.co.uk and get them to re-build it and then sell it at a higher premium complete. This all depends on interest, I am making any potential buyer aware of everything. As most know, I refused to even sell this rack until someone else had looked at it!

28-01-2010, 03:09 PM	#7
Craig S5 - Full Throttle Join Date: Jun 2009 Location: Guisborough Posts: 453 Casino cash: $4472	Lawsy, I know you wernt... out of interest anyone know what a fully refurbushed rack is worth?