Window Switch Trim Removal

**Mark CSL** · 26-06-2013, 11:36 PM

This is how to change the window switch trim I am fitting a carbon one

Tools needed are a Phillips Screw Driver

Pull up on the gear knob

It will come off in your hand

Then pull up on this part when off release the green connector

Then remove the 2 screws You can see the Green connector on the right

Unclip the window switches on each side there are 2 clips on each side

Fit the switches in the new panel then place it down from the astray to the front then fit the 2 screws

Fit the rest of the trims not forgetting to connect the green connector
This is the finished part

I sell the carbon ones PM me for details

NZ_M3 · 28-06-2013, 05:52 AM

You don't actually need to remove the gearnob Mark - you can separate the gaiter from the chrome ring and squeeze the SMG gaiter leather boot and the plastic ring through the chrome SMG gear housing and pull up and out of the way. The plastic ring on the SMG gaiter is very strong so it won't break - just squeez it enough to feed through the Chrome ring.

26-06-2013, 11:36 PM	#1
Mark CSL CSL Register Uber-poster! Join Date: Sep 2007 Location: Scotland Posts: 8,777 Casino cash: $42229	Window Switch Trim Removal This is how to change the window switch trim I am fitting a carbon one Tools needed are a Phillips Screw Driver Pull up on the gear knob It will come off in your hand Then pull up on this part when off release the green connector Then remove the 2 screws You can see the Green connector on the right Unclip the window switches on each side there are 2 clips on each side Fit the switches in the new panel then place it down from the astray to the front then fit the 2 screws Fit the rest of the trims not forgetting to connect the green connector This is the finished part I sell the carbon ones PM me for details __________________ www.procarkits.co.uk Last edited by Mark CSL; 26-06-2013 at 11:38 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

28-06-2013, 05:52 AM	#2
NZ_M3 S5, Sport On, DSC M-track Join Date: Jun 2008 Location: Auckland, New Zealand Posts: 1,434 Casino cash: $13579	You don't actually need to remove the gearnob Mark - you can separate the gaiter from the chrome ring and squeeze the SMG gaiter leather boot and the plastic ring through the chrome SMG gear housing and pull up and out of the way. The plastic ring on the SMG gaiter is very strong so it won't break - just squeez it enough to feed through the Chrome ring.