Quote:
Originally Posted by Olive
One more point.
The garage asked me about the tightening torque of the rear axle input nut. This is the one that holds the shaft of attachment of the shaft of transmission.
I know...I am not very clear. Here the piece I am looking for the torque :
Somebody ?  |
hi olive don’t think there is a torque for this ,, there is a crush washer/ bush Behind it’s more to do with setting the load on bearings , Definitely wouldn’t over tighten,or possibly end up with groaning bearings,, you could probably just take up the play on nut and lock back in place,, this nut is normally done when setting up the diff ,, I’d imagine if it’s really loose possibly bearings are a bit worn