Quote:
Originally Posted by JBird
 Nice work!
For the benifit of the trolls out there, the bloke on cutters just removes the lacquer with paint stripper, then leaves them raw. Not too bad an idea as sanding will destroy the brushed finish. I wonder if the Alu is pitted underneath, or if its in good enough cond re-cover them afterwards, either in venture sheild or clear coat? Might give this a go. |
From what I've read, if you lacquer/clear coat them after using paint stripper, after a while, water gets under the lacquer again and you're back round to square 1.
I suspect if you use paint stripper, you're better off just keeping a nice layer of wax/sealant on them and wiping them clean weekly/monthly.