Fitting flippers to bumper
 

Was just trying to fit mine to my new bumper and is there a knack to it so they sit bang on ?? :bigcry::bigcry:

Sledge hammer and cold chisel, if that doesn't work - blow torch :blalalala:.

What seems to be the problem with the alignment, I didn't think you could fit them wrongly?

Lol that would work ! :bigcry::blalalala:
Seems tight to slip on at the inside ends then tuck the flap at the top under the bumper , almost seems like they need trimming at the top part.

They do need a bit of persuasion, but shouldn't need trimming :)

They go in using a diagonal movement as I remember. Start at the inside end and move them upwards and inwards.

Thank you gents. :beer:

All sorted , just had to trim a little bit at the top.