Retirement is over Cesil - Page 5

s.mac · 15-01-2020, 07:14 PM

Looking good Paul

rstoughy · 27-01-2020, 08:51 AM

Again some decent progress over the weekend. Its getting close to going for paint now.

Replaced the flange on the exhaust center to rear silencer joint as it was non existent after 11yrs. Also fixed a small hole that had appeared in the center silencer.

This took the majority of Saturday afternoon to complete but worth the effort I think.

I have always taken stick from pals about having a Scorpion on the car and not a Supersprint or the likes but in fairness to Scorpion my £400 back box is still looking pretty decent after 11yrs

Exhaust clamps / flanges upon removal (usual)

The repaired hole in the center silencer

New OEM clamp fitted to flanged side of the system

Exhaust all bolted up into final position using new bolts, gaskets etc etc

Front end next so Back Plates, bearings and build up the brakes.

rstoughy · 27-01-2020, 09:02 AM

Also dragged this thing out of the corner it's been sitting in for the last 18 months.

Need the CSL off the ramp so I can get this thing done for the race season.

**CraigMillwardCroft** · 27-01-2020, 06:47 PM

Quote:

Originally Posted by rstoughy

Also dragged this thing out of the corner it's been sitting in for the last 18 months.

Need the CSL off the ramp so I can get this thing done for the race season.

Looks nice

rstoughy · 28-01-2020, 10:21 AM

Hopefully have the engine out in the next couple of weeks Craig and get it stripped and off to the machine shop.

**CraigMillwardCroft** · 28-01-2020, 11:30 AM

Quote:

Originally Posted by rstoughy

Hopefully have the engine out in the next couple of weeks Craig and get it stripped and off to the machine shop.

When does your season start

rstoughy · 28-01-2020, 12:01 PM

1st race for me will be May down at Donington

billyboysm3 · 29-01-2020, 04:06 PM

Quote:

Originally Posted by rstoughy

Also dragged this thing out of the corner it's been sitting in for the last 18 months.

Need the CSL off the ramp so I can get this thing done for the race season.

Wicked!!!!!

0-60Motorsports · 30-01-2020, 01:41 PM

Excellent job on the CSL. Looking forward to updates

rstoughy · 18-02-2020, 09:35 AM

Not really much to update as busy with house stuff at the minute but here is the current status.

Bit the bullet and just ordered up a new OEM Oil Cooler.
Got that all fitted up and have to say it does look good with all new rads / coolers etc in there. No flies, grime etc

Then turned my attention to the underside plastics for the tank. These were covered in what I can only assume was some kind of hardened waxoil. It required a scraper to come off and was no more waxy than a concrete slab.

All cleaned up well though and looking decent.

Next step is to get some fluids back in and get it fired up then off to the paint shop to get the bodywork done.

Nearly there

27-01-2020, 08:51 AM	#42
rstoughy S6, Sport On, Traction Off Join Date: Jun 2008 Location: Aberdeenshire Posts: 1,947 Casino cash: $25387	Again some decent progress over the weekend. Its getting close to going for paint now. Replaced the flange on the exhaust center to rear silencer joint as it was non existent after 11yrs. Also fixed a small hole that had appeared in the center silencer. This took the majority of Saturday afternoon to complete but worth the effort I think. I have always taken stick from pals about having a Scorpion on the car and not a Supersprint or the likes but in fairness to Scorpion my £400 back box is still looking pretty decent after 11yrs Exhaust clamps / flanges upon removal (usual) The repaired hole in the center silencer New OEM clamp fitted to flanged side of the system Exhaust all bolted up into final position using new bolts, gaskets etc etc Front end next so Back Plates, bearings and build up the brakes. __________________ Paul. Ooooft!!! 15yrs in the CSL and still loving it "shine on you crazy diamond" Last edited by rstoughy; 27-01-2020 at 09:37 AM.

27-01-2020, 09:02 AM	#43
rstoughy S6, Sport On, Traction Off Join Date: Jun 2008 Location: Aberdeenshire Posts: 1,947 Casino cash: $25387	Also dragged this thing out of the corner it's been sitting in for the last 18 months. Need the CSL off the ramp so I can get this thing done for the race season. __________________ Paul. Ooooft!!! 15yrs in the CSL and still loving it "shine on you crazy diamond"

28-01-2020, 10:21 AM	#45
rstoughy S6, Sport On, Traction Off Join Date: Jun 2008 Location: Aberdeenshire Posts: 1,947 Casino cash: $25387	Hopefully have the engine out in the next couple of weeks Craig and get it stripped and off to the machine shop. __________________ Paul. Ooooft!!! 15yrs in the CSL and still loving it "shine on you crazy diamond"

28-01-2020, 12:01 PM	#47
rstoughy S6, Sport On, Traction Off Join Date: Jun 2008 Location: Aberdeenshire Posts: 1,947 Casino cash: $25387	1st race for me will be May down at Donington __________________ Paul. Ooooft!!! 15yrs in the CSL and still loving it "shine on you crazy diamond"

30-01-2020, 01:41 PM	#49
0-60Motorsports S5 - Full Throttle Join Date: Aug 2008 Location: Kingdom of Bahrain Posts: 481 Casino cash: $3271	Excellent job on the CSL. Looking forward to updates __________________ EURO 04 M3 Current Mods: GC Coilovers, Eibach Sways, RE RCA?s, VCSL Bumper, OE CSL Boot, VCSL CF Rear Diffusor, DIETZ TV in Motion, SS Stepped Headers and catless, SS Res X Pipe, SS Race exhaust, OEM CSL Steering + interior, OEM CSL Intake, MSS54HP with HTE Tune, BBS CH's/LM?s FX-R Projectors + night breakers, STOPTECH ST60/40, RE Front strut brace, DINAN Rear Strut Brace,

15-01-2020, 07:14 PM	#41
s.mac CSL Register Uber-poster! Join Date: Jun 2008 Posts: 4,247 Casino cash: $15600	Looking good Paul

18-02-2020, 09:35 AM	#50
rstoughy S6, Sport On, Traction Off Join Date: Jun 2008 Location: Aberdeenshire Posts: 1,947 Casino cash: $25387	Not really much to update as busy with house stuff at the minute but here is the current status. Bit the bullet and just ordered up a new OEM Oil Cooler. Got that all fitted up and have to say it does look good with all new rads / coolers etc in there. No flies, grime etc Then turned my attention to the underside plastics for the tank. These were covered in what I can only assume was some kind of hardened waxoil. It required a scraper to come off and was no more waxy than a concrete slab. All cleaned up well though and looking decent. Next step is to get some fluids back in and get it fired up then off to the paint shop to get the bodywork done. Nearly there __________________ Paul. Ooooft!!! 15yrs in the CSL and still loving it "shine on you crazy diamond"