Can Seat tilt angle be adjusted? **SEAT ADJUSTMENT GUIDE** - Page 4

0-60Motorsports · 25-02-2012, 10:51 AM

This is awesome. Next time My car goes to the shop i"ll remove the seats and adjust the height.

thrashermax · 03-03-2013, 09:10 AM

Since October 2012 I've had terrible back pain... I blamed it on bad posture at work and moving large bits of furniture around the house but in October 2012 something else happened... I bought my CSL.

Thank you for this thread... my seats were too low.

I got my seats out today, adjusted them then went out for drive... so far my back feels bit better. Next week I have my usual 250 miles for the week.. so I will know for sure. My back was so bad that I have been walking around like hunchback.

Anyway, enough of my problems... photos to go with the words on this brilliant thread...

Pip1968 · 05-03-2013, 03:32 PM

Very helpful ThrasherMax

. A picture paints a thousand words as they say. Any pictures of the bolts that need to be undone and done up to make the seat adjustment?

I have no intention of adjusting mine but always helpful if I do and more importantly, for everyone else.

Pip

thrashermax · 05-03-2013, 06:46 PM

Quote:

Originally Posted by Pip1968

Very helpful ThrasherMax

. A picture paints a thousand words as they say. Any pictures of the bolts that need to be undone and done up to make the seat adjustment?

It's the last two pictures that show the bolts to change the seat height. You can see the three possible positions.

Since, changing I have done 150 miles, including trips to Heathrow from Horsham... back is 100% fine!

select · 07-01-2016, 09:13 PM

Quote:

Originally Posted by MaKSiNG

This might sound like a stupid question but can you see what setting the seat is on before taking anything apart?
[...]

I need to resurrect this thread, because i've got the same question..
Didn't take a closer at the seats yet, but i am curious to know in which position they currently are in if its possible without removing them. Not desperate to take them out, if its not necessary.

I am a bit late to the party however that be, thanks for the pictures thrashermax.

Wurzelkönig · 16-04-2016, 07:23 PM

Hey guys, greetings from bavaria the home of our babys,

Am i doing something wrong? Using the method that was posted here, everything fine. Didn't get an airbag light or anything. But i only could raise the rear to the middle position. The steelcable of the tilt release thing isn't long enough. I would love to sit a little more upright, i'm a big fella and would love to better reach the steering wheel.

Cheers
Alex

mouser73 · 21-05-2016, 08:17 PM

Did mine today. Lowest on the back and middle on the front. A friend on this forum also told me the lumbar cushion could be adjusted. So did that too. Much better although I might bulk out the lumbar a bit more. I have found that these kind of seats (I had a 987 Spyder before this), offer little/no lumbar support, so you end up slouching into the seat. This gives me neck ache. Getting older I guess;-)

Cheers.

jonnysideways · 03-09-2016, 12:25 PM

quick q. as I need to do mine as it feels like i am constricted and previous car was ok.

so the 2 questions I have is.

1. Please confirm the default BMW position from new.
2. what is the general preferred setting (6 foot driver)

cheers

John

CSLScot · 27-07-2021, 11:00 PM

Been meaning to do mine for.....years. Decided to bite the bullet today. Seat out no problem, grommet screw & trim off no problem, changed seat height to lowest rear, middle front (the passenger side has been like that since I bought & driver side was set to highest rear & highest front). Right then, reassembly should be the easy bit.....this is where I hit a problem.

With the lowered seat position, the gap between the seat cover & part of the tilt componentry was significantly smaller & I could not for the life of me get the seat trim back on. After many, many attempts & a lot of swearing, I gave up & called a coach trimmer (one of the last genuine & quality coach trimmers in Scotland) who happens to stay nearby. He got it back on whilst I nipped back to the house for the trim bolts I'd accidentally left there - 'tricks of the trade' he said so I have no idea how he managed it. Ah well, seating position much better now & should never need adjusted again!

25-02-2012, 10:51 AM	#31
0-60Motorsports S5 - Full Throttle Join Date: Aug 2008 Location: Kingdom of Bahrain Posts: 481 Casino cash: $3271	This is awesome. Next time My car goes to the shop i"ll remove the seats and adjust the height. __________________ EURO 04 M3 Current Mods: GC Coilovers, Eibach Sways, RE RCA?s, VCSL Bumper, OE CSL Boot, VCSL CF Rear Diffusor, DIETZ TV in Motion, SS Stepped Headers and catless, SS Res X Pipe, SS Race exhaust, OEM CSL Steering + interior, OEM CSL Intake, MSS54HP with HTE Tune, BBS CH's/LM?s FX-R Projectors + night breakers, STOPTECH ST60/40, RE Front strut brace, DINAN Rear Strut Brace,

16-04-2016, 07:23 PM	#36
Wurzelkönig Wonky 'L' after Washing Join Date: Oct 2015 Location: Ingolstadt, Germany Posts: 1 Casino cash: $281	Can't reach the top hole in the back Hey guys, greetings from bavaria the home of our babys, Am i doing something wrong? Using the method that was posted here, everything fine. Didn't get an airbag light or anything. But i only could raise the rear to the middle position. The steelcable of the tilt release thing isn't long enough. I would love to sit a little more upright, i'm a big fella and would love to better reach the steering wheel. Cheers Alex

03-09-2016, 12:25 PM	#38
jonnysideways S4 - Getting the hang of it Join Date: May 2012 Location: North West Posts: 246 Casino cash: $1744	quick q. as I need to do mine as it feels like i am constricted and previous car was ok. so the 2 questions I have is. 1. Please confirm the default BMW position from new. 2. what is the general preferred setting (6 foot driver) cheers John __________________ A hedge is better than a tree. Last edited by jonnysideways; 03-09-2016 at 01:07 PM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
SPARCO LUMBAR SEAT SUPPORT	cslbecks	Parts For Sale	1	17-01-2009 10:43 PM
Seat Belt Fastener, where is it Bolted to?	Rags	Technical Area	0	16-10-2008 12:56 PM
Extra seat padding - with pics	rs32	Main Message Centre	15	22-08-2008 09:37 PM
CSL Taking a back seat	neil	Main Message Centre	1	18-12-2007 11:32 PM
BMW M3 CSL DRIVER'S SEAT (2003)	Mark CSL	Parts For Sale	0	26-09-2007 08:10 PM

03-03-2013, 09:10 AM	#32
thrashermax S4 - Getting the hang of it Join Date: Oct 2012 Location: Horsham, West Sussex Posts: 149 Casino cash: $1781	Since October 2012 I've had terrible back pain... I blamed it on bad posture at work and moving large bits of furniture around the house but in October 2012 something else happened... I bought my CSL. Thank you for this thread... my seats were too low. I got my seats out today, adjusted them then went out for drive... so far my back feels bit better. Next week I have my usual 250 miles for the week.. so I will know for sure. My back was so bad that I have been walking around like hunchback. Anyway, enough of my problems... photos to go with the words on this brilliant thread...

05-03-2013, 03:32 PM	#33
Pip1968 S5, Sport Off, DSC M-track Join Date: Dec 2007 Location: Kent, England Posts: 940 Casino cash: $8383	Very helpful ThrasherMax . A picture paints a thousand words as they say. Any pictures of the bolts that need to be undone and done up to make the seat adjustment? I have no intention of adjusting mine but always helpful if I do and more importantly, for everyone else. Pip

21-05-2016, 08:17 PM	#37
mouser73 Mode S1 - Starting Out Join Date: Oct 2015 Location: Somerset Posts: 21 Casino cash: $4394	Did mine today. Lowest on the back and middle on the front. A friend on this forum also told me the lumbar cushion could be adjusted. So did that too. Much better although I might bulk out the lumbar a bit more. I have found that these kind of seats (I had a 987 Spyder before this), offer little/no lumbar support, so you end up slouching into the seat. This gives me neck ache. Getting older I guess;-) Cheers.

27-07-2021, 11:00 PM	#39
CSLScot S4 - Getting the hang of it Join Date: Jan 2012 Location: Edinburgh Posts: 147 Casino cash: $6357	Been meaning to do mine for.....years. Decided to bite the bullet today. Seat out no problem, grommet screw & trim off no problem, changed seat height to lowest rear, middle front (the passenger side has been like that since I bought & driver side was set to highest rear & highest front). Right then, reassembly should be the easy bit.....this is where I hit a problem. With the lowered seat position, the gap between the seat cover & part of the tilt componentry was significantly smaller & I could not for the life of me get the seat trim back on. After many, many attempts & a lot of swearing, I gave up & called a coach trimmer (one of the last genuine & quality coach trimmers in Scotland) who happens to stay nearby. He got it back on whilst I nipped back to the house for the trim bolts I'd accidentally left there - 'tricks of the trade' he said so I have no idea how he managed it. Ah well, seating position much better now & should never need adjusted again!