Vanos broken

[NZ_M3]

I am starting to wonder if you have the highest number (and most $$$) of warranty claims of all the CSLs in the world Mark

[_Nathan_]

So it hasn't gone again, they just didn't replace enough stuff first time round. Happened to a guy on MTorque too. Replaced unit and gears and all was fine.

[Mark CSL]

Originally Posted by NZ_M3

I am starting to wonder if you have the highest number (and most $$$) of warranty claims of all the CSLs in the world Mark

Yip I do get a lot of problems sorted under warranty

Originally Posted by _Nathan_

So it hasn't gone again, they just didn't replace enough stuff first time round. Happened to a guy on MTorque too. Replaced unit and gears and all was fine.

We shall see today when the cam cover comes off

[sailorbaz]

When mine went almost 2 year ago, I hadn't noticed any change in tone, fuel consumption and most importantly BHP. It was when it was in the workshop at BMW someone said it didn't sound like the 'other' CSL that was in and sounded a bit 'rough'. SO they brought the 'other' CSL in, a certain Stevie Gill's, and right enough, mine was a little more rattly. As it was under warranty, they removed the required parts and found it was indeed on its way out and replaced everything that looked sh1t!

This was when Stevie not long had his CSL so it was sounding standard back then.

After track days mine always sounds really tinny and rattly, anyone else get that?

Good luck with yours Mark, in at the usual dealers?

[glendog74]

Originally Posted by sailorbaz

After track days mine always sounds really tinny and rattly, anyone else get that?

Mine has started making a very slight rattle on tickover from cold since my recent track day at Donny. Gonna see what it's like after this weekend's fun and if its worse take it in!

[Mark CSL]

Yes baz at the garage i always use

They can do a vanos test on the unit when it is on the car
The tec said it was grinding when he ran the vanos test and it failed the test
he wont know if it needs the gears till he removes the cam cover and can see if the gears have any ware

[XPorker]

Originally Posted by mark csl

Yes baz at the garage i always use

They can do a vanos test on the unit when it is on the car
The tec said it was grinding when he ran the vanos test and it failed the test
he wont know if it needs the gears till he removes the cam cover and can see if the gears have any ware

Normally (as I understand it) a Vanos test is run first. If the test is failed the gears are replaced. If after their replacement the test results don't fall within the specified parameters the Vanos unit is replaced.

The lads at Simpson MS said mine was noisy and I thus took it to my local dealer and they replaced it (under warranty) The improvement in power at the top end of the rev range after its replacement was VERY noticeable.