DSC Failed

mattbedford · 31-05-2009, 07:43 PM

My DSC light is permanently lit up. Upon checking the manual, it says it has failed and to take it to a dealer. Does anyone know if im ok to drive it still and will it cause any further problems? Im assuming its going to cost a lot to fix it aswell ??

2bar boost · 31-05-2009, 07:59 PM

How was the car being driven when the light came on and stayed on??
Also is it red or amber... not sure if the dsc goes red but just curious!

Reason I ask is that the last time I gave it some beans the smg light came on and stayed on.. But after a couple of days it reset itself and was faultless for Milbrook too

Fingers crossed its just a sensor thats had wobbly coz in my experience anything BMW is costly

mattbedford · 31-05-2009, 08:16 PM

Its yellow i think. And there is a warning light aswell on the warning light section in red. I was only tootling along slowly when it came on and i hadnt been driving it hard before hand either. It happened yesterday, started her up this morning and the lights were still on. Not driven it yet as i didnt know if i would do it more harm. Might try it and see if the traction control is working when i push it as it could be a faulty sensor like you say. Hope so....

SpineOnABap · 01-06-2009, 08:32 AM

It'll be fine to drive and you won't have any traction control. Your ABS is probably shut down too.
There are a few sensors that can have that effect, the dealer will be able to tell which one.

kbird · 01-06-2009, 07:15 PM

Mine has the same fault, its the DSC sensor on the master cylinder. Part is about Â£75 plus fitting

mattbedford · 01-06-2009, 08:02 PM

The DSC has definately failed . Just been for a blast and its obviously not on. SIdeways everywhere!

. Will this still be Â£75 plus labour kbird??

kbird · 01-06-2009, 08:35 PM

Should be.........

mattbedford · 01-06-2009, 09:53 PM

Ok cheers for everyones input.

NZ_M3 · 02-06-2009, 01:24 AM

I had this happen to me also ... it's the DSC pressure sensor on the brake master cylinder: (Part no.2 below): part number 34521164458

Warranty repair luckily - not a cheap sensor by any means and requires a brake bleed.

mattbedford · 02-06-2009, 12:49 PM

Looks like it might be costly then.....

31-05-2009, 07:43 PM	#1
mattbedford S3 - On the open road Join Date: Jan 2009 Location: Manchester Posts: 101 Casino cash: $725	DSC Failed My DSC light is permanently lit up. Upon checking the manual, it says it has failed and to take it to a dealer. Does anyone know if im ok to drive it still and will it cause any further problems? Im assuming its going to cost a lot to fix it aswell ??

01-06-2009, 08:02 PM	#6
mattbedford S3 - On the open road Join Date: Jan 2009 Location: Manchester Posts: 101 Casino cash: $725	The DSC has definately failed . Just been for a blast and its obviously not on. SIdeways everywhere!. Will this still be Â£75 plus labour kbird??

31-05-2009, 07:59 PM	#2
2bar boost S4 - Getting the hang of it Join Date: Oct 2008 Location: South East Posts: 229 Casino cash: $793	How was the car being driven when the light came on and stayed on?? Also is it red or amber... not sure if the dsc goes red but just curious! Reason I ask is that the last time I gave it some beans the smg light came on and stayed on.. But after a couple of days it reset itself and was faultless for Milbrook too Fingers crossed its just a sensor thats had wobbly coz in my experience anything BMW is costly

31-05-2009, 08:16 PM	#3
mattbedford S3 - On the open road Join Date: Jan 2009 Location: Manchester Posts: 101 Casino cash: $725	Its yellow i think. And there is a warning light aswell on the warning light section in red. I was only tootling along slowly when it came on and i hadnt been driving it hard before hand either. It happened yesterday, started her up this morning and the lights were still on. Not driven it yet as i didnt know if i would do it more harm. Might try it and see if the traction control is working when i push it as it could be a faulty sensor like you say. Hope so....

01-06-2009, 08:32 AM	#4
SpineOnABap S5, Sport Off, DSC M-track Join Date: May 2008 Location: Earth Posts: 561 Casino cash: $5714	It'll be fine to drive and you won't have any traction control. Your ABS is probably shut down too. There are a few sensors that can have that effect, the dealer will be able to tell which one.

01-06-2009, 07:15 PM	#5
kbird S3 - On the open road Join Date: Nov 2008 Location: Somerset Posts: 96 Casino cash: $2926	Mine has the same fault, its the DSC sensor on the master cylinder. Part is about Â£75 plus fitting

01-06-2009, 08:35 PM	#7
kbird S3 - On the open road Join Date: Nov 2008 Location: Somerset Posts: 96 Casino cash: $2926	Should be.........

01-06-2009, 09:53 PM	#8
mattbedford S3 - On the open road Join Date: Jan 2009 Location: Manchester Posts: 101 Casino cash: $725	Ok cheers for everyones input.

02-06-2009, 01:24 AM	#9
NZ_M3 S5, Sport On, DSC M-track Join Date: Jun 2008 Location: Auckland, New Zealand Posts: 1,434 Casino cash: $13579	I had this happen to me also ... it's the DSC pressure sensor on the brake master cylinder: (Part no.2 below): part number 34521164458 Warranty repair luckily - not a cheap sensor by any means and requires a brake bleed.

02-06-2009, 12:49 PM	#10
mattbedford S3 - On the open road Join Date: Jan 2009 Location: Manchester Posts: 101 Casino cash: $725	Looks like it might be costly then.....