[shane@mbtech]

I then thoroughly cleaned the underfloor area and under arches. I then etch primed any bare metal, applied a couple of coats of stone chip and then a few coats of red.






I also routed my brake lines


In went the fuel tank after a good clean


I then started to piece together the jigsaw








I then fitted the rear brakes, renewed the rear calipers. And fitted stud kit.



I fitted the alcons to the front


I then fitted the castor bushes to the front arms, fitted the front roll bar, cleaned up the wishbones, fitted new engine mounts, fitted new PAS pipe. New track rod ends and tie tods.





I started the airbox install last night. Updates coming next week.
Bumpers are away getting refreshed and exhaust fitting next week.