CSL Register - New clutch & flywheel: Do I need to do a software reset or anything?

CSL Register (http://www.cslregister.com/forum/index.php)

- Main Message Centre (http://www.cslregister.com/forum/forumdisplay.php?f=8)

- - New clutch & flywheel: Do I need to do a software reset or anything? (http://www.cslregister.com/forum/showthread.php?t=12337)

Gibbo

07-07-2014 11:37 PM

New clutch & flywheel: Do I need to do a software reset or anything?

Hi there

My clutch went in my SMG, am installing new clutch kit, flywheel, engine mounts, transmission mounts and changing few other bits in transmission whilst it's out.

When all installed can I just drive the car or will it need SMG reset or calibration and if so what do I need or is there a how to guide please?

NBTBRV8

08-07-2014 09:47 AM

Quote:

Originally Posted by Gibbo (Post 171209)

You need to do a teach in from memory. Have you got access to DIS or the aftermarket INPA.

Gibbo

08-07-2014 11:40 AM

Quote:

Originally Posted by NBTBRV8 (Post 171216)

You need to do a teach in from memory. Have you got access to DIS or the aftermarket INPA.

Yes I've got INPA and DIS I think along with a special cable.

Is there a guide anywhere online for doing this reset? Do I need to bleed the system or anything and again if so how please?

NBTBRV8

08-07-2014 12:34 PM

Quote:

Originally Posted by Gibbo (Post 171218)

Yes I've got INPA and DIS I think along with a special cable.

Is there a guide anywhere online for doing this reset? Do I need to bleed the system or anything and again if so how please?

There is a guide on here about reteaching the system that the NZ guy posted online. In the DIS you need to create a service measure to run the reteach.

All times are GMT +1. The time now is 01:03 PM.