Rubbing down Carbon Fibre, no no?
 

Just thinking about tarting the little splitters up at the front of the car, they are already looking a bit tired from the odd scratch and stone chip! :(

I was thinking about rubbing them down to remove the surface blemishes and then re-lacquering them, I have some nice high build stuff at home from my Dad's garage that leaves a lovely deep shine! :smokin:

What I don't want to do those is fook the splitters up by rubbing the surface down, so long as I only go down to the lacquer it should be ok shouldn't it?

this thread is worth a look Dan :)

http://www.cslregister.com/forum/sho...ight=splitters

Perfect, your a star thanks mate! Will whip them off and run them up Dad's bodyshop this weekend then! ;) :smokin:

ive done it takes hoursssssssssssssssssssssss:bigcry: get hold of gareth from detailedobsession he can get meguiars 3000 grit paper :supz: mine got ruined teaching a brand new boxster s a lesson :hahaha:

Funnily enough I spoke to Gaz earlier mate thanks! Lol

I'll give this a go, it'll be fine just to finish them off a bit better, they'll get beat to hell around track and going to Germany and back anyway! :whistle:

mine need doing as well but might wait until june :whistle:

Mine are the same.:bigcry:

:hahaha: :hahaha:

I need to do mine too :bigcry:

im actually gonna do mine again in the summer and once done get some stone chip film fitted

I've got some Ventureshield stuff on my wing mirrors but it's not across the whole lot so I'm not overly happy with it :bigcry:

Good idea on doing the splitters though :thumbs: