View Full Version : creaking door cards
Hi
When driving my CSL there is some creaking noise coming from the rear door cards which winds me up.
Has anyone else have this and is this easily fixed
Regards
Faisal
shimmy
03-12-2014, 05:19 PM
Hi
When driving my CSL there is some creaking noise coming from the rear door cards which winds me up.
Has anyone else have this and is this easily fixed
Regards
Faisal
yes and no
cslsuperfan
03-12-2014, 07:44 PM
Hi
When driving my CSL there is some creaking noise coming from the rear door cards which winds me up.
Has anyone else have this and is this easily fixed
Regards
Faisal
Faisal you hearing must be pin sharp!!
Mark CSL
03-12-2014, 08:56 PM
are you sure its not the back seats drop the 2 down and see if its gone
then if it has i will tell you how to sort this :thumbs:
Marv968
03-12-2014, 09:03 PM
There's a thread on Cutters about the rear creaking noise. I've done the fix on my car, but as it's now tucked away I'm not sure if it has banished the noise.
mattCSLnut
03-12-2014, 09:31 PM
are you sure its not the back seats drop the 2 down and see if its gone
then if it has i will tell you how to sort this :thumbs:
Spot On :thumbs: more often than not it's the two upper parts of the 60/40 split/fold down seats rubbing together and/or against the opening aperture due to misalignment.
Mine was chronic right after I got my Cecil back from the boot floor repair :banghead: fortunately our Garther got it sorted by readjusting the upper rear seats and replacing broken upper near side seat bolster :thumbs:
are you sure its not the back seats drop the 2 down and see if its gone
then if it has i will tell you how to sort this :thumbs:
Hi Mark
i think its most likely the rear seats, how do you sort this,
@cslsuperfan - hahahaha the engine noise soon drowns out the creaking
Thanks
Faisal
Mark CSL
04-12-2014, 04:38 PM
You can re ajust the rear seats or drop them down and pop a little silicon spray along the top back rubber part when it meets the rear shelf :thumbs:
You can re ajust the rear seats or drop them down and pop a little silicon spray along the top back rubber part when it meets the rear shelf :thumbs:
Hi Mark
Thanks for the info
Ill give that a go
vBulletin® v3.8.1, Copyright ©2000-2025, Jelsoft Enterprises Ltd.