Window Switch Trim Removal

[Mark CSL]

This is how to change the window switch trim I am fitting a carbon one :thumbs:
Tools needed are a Phillips Screw Driver
[/URL]http://i260.photobucket.com/albums/ii14/markcsl/csl/IMG_5658_zpsa8fc0398.jpg (http://i260.photobucket.com/albums/ii14/markcsl/csl/IMG_5658_zpsa8fc0398.jpg)

Pull up on the gear knob :gayfight: It will come off in your hand :hahaha:
http://i260.photobucket.com/albums/ii14/markcsl/csl/IMG_5659_zpsb6e9f1c6.jpg (http://i260.photobucket.com/albums/ii14/markcsl/csl/IMG_5659_zpsb6e9f1c6.jpg)

Then pull up on this part when off release the green connector
http://i260.photobucket.com/albums/ii14/markcsl/csl/IMG_5660_zpsb5ca8874.jpg (http://i260.photobucket.com/albums/ii14/markcsl/csl/IMG_5660_zpsb5ca8874.jpg)

Then remove the 2 screws You can see the Green connector on the right
http://i260.photobucket.com/albums/ii14/markcsl/csl/IMG_5662_zpsc70288db.jpg (http://i260.photobucket.com/albums/ii14/markcsl/csl/IMG_5662_zpsc70288db.jpg)

Unclip the window switches on each side there are 2 clips on each side
http://i260.photobucket.com/albums/ii14/markcsl/csl/IMG_5665_zps3852d0c5.jpg (http://i260.photobucket.com/albums/ii14/markcsl/csl/IMG_5665_zps3852d0c5.jpg)

Fit the switches in the new panel then place it down from the astray to the front then fit the 2 screws
[URL="http://s260.photobucket.com/user/markcsl/media/csl/IMG_5667_zps207c2f6b.jpg.html"]http://i260.photobucket.com/albums/ii14/markcsl/csl/IMG_5667_zps207c2f6b.jpg (http://i260.photobucket.com/albums/ii14/markcsl/csl/IMG_5667_zps207c2f6b.jpg)

Fit the rest of the trims not forgetting to connect the green connector
This is the finished part
http://i260.photobucket.com/albums/ii14/markcsl/csl/IMG_5668_zps9e1d3b88.jpg (http://s260.photobucket.com/user/markcsl/media/csl/IMG_5668_zps9e1d3b88.jpg.html)

I sell the carbon ones PM me for details :thumbs:

[NZ_M3]

You don't actually need to remove the gearnob Mark - you can separate the gaiter from the chrome ring and squeeze the SMG gaiter leather boot and the plastic ring through the chrome SMG gear housing and pull up and out of the way. The plastic ring on the SMG gaiter is very strong so it won't break - just squeez it enough to feed through the Chrome ring.